By setting the PWR_UP bit in the CONFIG register to 1, the device enters standby-I mode. Standby-I mode is used to minimize average current consumption while maintaining short start up times. In this
By setting the PWR_UP bit in the CONFIG register to 1, the device enters standby-I mode. Standby-I mode is used to minimize average current consumption while maintaining short start up times. In this mode only part of the crystal oscillator is active. Change to active modes only happens if CE is set high and when CE is set low, the nRF24L01 returns to standby-I mode from both the TX and RX modes.
1.本站遵循行业规范，任何转载的稿件都会明确标注作者和来源；2.本站的原创文章，请转载时务必注明文章作者和来源，不尊重原创的行为我们将追究责任；3.作者投稿可能会经我们编辑修改或补充。
相关文章
使用Docker分分钟启动常用应用 - 编程玩家
2017-04-10 14:00
我，编程和大学 - 外婆的彭湖湾
2017-04-09 17:04
初学编程一周的感想 - 陈老仁
2017-03-20 10:01
编程思想之——人是活的，程序是死的 - 追随微笑
2017-03-03 09:00
网友点评
精彩导读
热门资讯
关注我们
